Installation

Step 1 – Before you start

Before you start installing the Wedgiecover you need to make sure all the connections are tight.  Make sure the connection on the LNB and the connection for aligning the dish is tight. (see figure 1)  If these connection are not tight, then when you put the Wedgiecover over the dish and tighten it, your dish may move slightly and cause you to reduce or lose your satellite signal.

 Figure 1 – Securing the connections.  

Figure 1 – Securing the connections.

Step 2 – Installing the Wedgiecover

Place the Wedgiecover over the front of the entire satellite dish including the arm at the bottom and the LNB.  Make sure  that the bottom of the Wedgiecover (this is the fold or sew line of the Wedgiecover) lines up in the center of the arm that hold the LNB (see figure 2) and that the draw strings are at the bottom of the satellite dish.   Pull the cover over the entire dish.

Figure 2 – Lining up your Wedgiecover

Step 3 – Tightening the Wedgiecover

 While holding the draw strings, make sure the cover is over the back of the satellite dish and slowly pull the draw strings.  This will start to tighten the cover over the entire dish.  While holding the draw strings tight, pull the Wedgiecover tight all around the dish to ensure that there is no stack in the Wedgiecover. 

 Wrap the draw strings around the arm of the satellite dish and tie the strings together.  (see figure 3)

 Check to make sure that there is no slack around the Wedgiecover where snow or rain can build up on the Wedgiecover.  If this happens then just untie the Wedgiecover and re-install.  Some minor slack in the Wedgiecover is fine, as long as  snow or rain can not build up on the cover.

 Figure 3 – Tying your Wedgiecover

Once you have installed your Wedgiecover the it should look like Figure 4.

Figure 4 – Final Look

That’s it your Wedgiecover is Installed.

There is no maintenance required with your Wedgiecover, just sit back and enjoy your satellite T.V.